MZ/MuZ Riders
A community for owners and riders or MZ Motorcycles, Scooters, and ATVs.
Mikuni intake manifold
Moderators: DAVID THOMPSON, phlat65
3 posts
• Page 1 of 1
Mikuni intake manifold
by Robmzetz » Wed Jan 26, 2022 5:06 pm
Hi. I hope you knowledgeable lot can shed a little light for me. I have bought a mikuni vm30 carb to replace my tired bing. The inlet manifold is clamped by the carb inlet whereas the mikuni is clamped by the inlet. My. Question is will the original inlet manifold which I believe was for a bvf carb fit the mikuni and if so any advice on where to find one in the UK would be greatly appreciated. Many thanks. Rob.
- Robmzetz
- Posts: 6
- Joined: Sat Oct 23, 2021 1:31 pm
Re: Mikuni intake manifold
by Puffs » Thu Jan 27, 2022 5:43 am
Removed
Last edited by Puffs on Mon Jan 06, 2025 10:43 am, edited 2 times in total.
-
Puffs - Posts: 2008
- Joined: Tue Jan 16, 2018 11:20 am
- Location: Ardennes, Belgium.
Re: Mikuni intake manifold
by Robmzetz » Thu Feb 03, 2022 4:06 pm
Many thanks for the reply Puffs. Sorry it took me so long. I'm a technophobe. I got a standard inlet manifold and followed the instructions on an article I found. No problem at all. Thanks again.
- Robmzetz
- Posts: 6
- Joined: Sat Oct 23, 2021 1:31 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 102 guests