Page 1 of 1

125 RT START ENGINE

PostPosted: Thu Jan 21, 2010 6:47 pm
by loykatoni
I HAVE A PROBLEM WITH MY BIKΕ,Ι FELLWITH MY BIKE.AFTER THE FALL I HAVE DEALT WITH THE FOLLOWING SITUATIONS:SOMETIMES THE STARTER DOESNT WORK ,WHEN IT DOES WORK ,IT SOUNDS LIKE IT STILL PROVIDES POWER TO THE ENGINE,DESPITE THE FACT THAT THE MOTOR IS RUNNING,THERE IS A MATTALIK NOISE NEAR THE GEAR BOX.THIS PROBLEMS SEEMS TO HAVE EMTIED THE BATTERY.COULD YOU POSSIBLY OFFER ME ANY SUGGESTIONS,FOR WHAT MIGHT DE HAPPENING??? :cry: :cry: :cry: :cry: :cry: :cry: :cry:

Re: 125 RT START ENGINE

PostPosted: Thu Jan 21, 2010 10:05 pm
by DAVID THOMPSON
under the seat just behind the bolt that holds the gas tank on is the starter relay..
some times they fail
in at least one case a rider reported to me that its contacts stuck on....making motor crank
also the switch on the handle bar may be sticking ..it may have been damaged but is not showing damage
dave

Re: 125 RT START ENGINE

PostPosted: Fri Jan 22, 2010 7:44 am
by loykatoni
thanks for the advice, i will check it..

Re: 125 RT START ENGINE

PostPosted: Mon May 03, 2010 1:21 pm
by loykatoni
thanks that was the problem.. :-)

Re: 125 RT START ENGINE

PostPosted: Mon May 03, 2010 1:57 pm
by loykatoni
What is the amaunt of preasure in the front/rear tire for RT 125

Re: 125 RT START ENGINE

PostPosted: Sun May 16, 2010 6:07 am
by stephendacosta
That depends of the manufacturer of the tire. For optimum wear, reduce the recommended pressure on the tire sidewall by 10%. This bit of information is from a tire engineer for Goodyear. For maximim cornering footprint, you would use a lower pressure; I have not worked out what is best, yet. David Thompson might have a little more experience for that.--Steve

Re: 125 RT START ENGINE

PostPosted: Sun May 16, 2010 9:14 am
by djsbriscoe
Hi,
From the user manual.
26 psi front, 33 psi rear at <=150KG weight.
maximum load 26 psi front and 38 psi rear.

David.